Try This: Pressed Flower Luminaria

article image
by Pixabay/Ri_Ya

The following is an excerpt from Weekend Handmade by Kelly Wilkinson (STC Craft, 2011). The excerpt is from chapter 2, “Grow.”

Pressed Flower Luminaria 

These lanterns give off a soft, ethereal light, perfect for adding glow to outdoor gatherings or indoor suppers. They also show off dried flowers in a spare, modern way—pressed between gauzy panels made from wax paper. As twilight fades to night, the luminaria glow brighter and brighter.

Finished dimensions 

• 4 1/2-inch cube


• Foraged flowers or foliage, such as ferns, leaves, rock rose, and Queen Anne’s Lace (see *Note below)
• Wax paper
• Japanese washi tape (paper tape)
• Votive candle in glass holder or battery-operated flameless LED tealight candle
• Paper towels
• Heavy books or a flower press
• Craft knife
• Clear acrylic grid ruler
• Self-healing cutting mat
• Iron and ironing board

*Note: Delicate leaves and flowers will dry faster than other types of specimens. Choose specimens that will allow a lot of contact between the sheets of wax paper so the sheets will adhere to each other.

Press Floral Materials 

Arrange freshly picked floral materials flat between two paper towels, and then place the paper towels between the pages of a heavy book or flower press. If using a book, stack other books on top to weigh down. Let dry completely. This will take a few days.

Make Panels 

1. Using a craft knife, cut four 9- by 4 1/2-inch rectangles of wax paper.

2. Set iron to medium. When hot, place a flower or foilage on one side of the wax paper rectangle. You will fold the other half on top and seal to create a square panel, so arrange the flower or foliage within the rectangle accordingly. Keep in mind you can place the flower or foliage so it runs beyond the edge of the paper since you can trim after making the sealed wax paper square.

3. Fold the rectangle of wax paper in half to create a square so the pressed item is sandwiched between the two layers of wax paper. Press along the folded edge with your finger, making sure the edges are aligned.

4. Seal with the iron, pressing over the wax paper lightly and quickly. The iron will fuse the two pieces of wax paper into one sheet.

5. Repeat steps 2 to 4 so you have four sealed square panels. Trim, if necessary.

Create Lanterns 

1. Lay two floral panels side-by-side with right sides up and edges touching. Orient the panels as you want them to appear in the finished lantern.

2. Cut a 5-inch length of Japanese washi tape. Center the tape over the join between the panels and press in place, letting the tape extend 1/4-inch at the ends. Flip the floral panels over and press the tape ends to the wrong sides of the panels.

3. Fold the panels, wrong sides together, at the join and run your fingers along the fold to make a sharp crease in the tape. This will allow the panels to be positioned at 90-degree angles in the finished lantern.

4. Continue joining the remaining floral panels in the same manner to make a floral sleeve. For the final join you may need to adjust how you tape the panels together by placing the tape along one edge of a panel so half of its width overhangs, and then attaching the neighboring panel.

5. Set the floral sleeve in the desired location and then place a votive candle in a glass holder or LED tealight in the center of the sleeve.

Copyright © Weekend Handmade, by Kelly Wilkinson, published by STC Craft | Melanie Falick Books, 2011. 

To view the “Weekend Handmade” trailer, peek inside the book, and get the scoop on upcoming promotions, visit the STC Craft blog.