Wood Gasification: A Renewable Fuel Option to Power Your Vehicle

Burning wood for fuel is an inexpensive and renewable alternative to gasoline.


| January/February 1981



Couple in wood gas truck

This Iowa couple “cut” their travel costs by using wood gasification in their truck.


PHOTO: MOTHER EARTH NEWS STAFF

As even greater numbers of folks turn to renewable fuels to fulfill their energy needs, the potential of wood gasification is being rediscovered. Most people today aren’t strangers to the idea of warming homes or cooking foods with wood, but few realize that the ligneous hydrocarbon can yield a viable — and proven — substitute for gasoline (known as “producer gas” or “gengas”) ... a replacement that might just be the closest thing to a “free ride” in existence today!

Wood Gas: An Old Idea Reborn

Throughout the lean years of the Second World War, civilians in Europe — and, to a lesser extent, here at home — took advantage of wood energy to power vehicles and drive stationary engines. (See How to Run Your Own Car on Wood.) Today, the concept is just beginning to enjoy a new wave of interest as a result of excessive gasoline prices ... and Steve and Lois Nunnikhoven — of Oakville, Iowa — are among the people who are re-pioneering wood-powered vehicle research.

The husband and wife, you see, run a small woodstove manufacturing business and offer delivery service to their customers ... a practice which used to cost the firm hundreds of dollars in transportation expenses each month. So, to ease their “gas pains,” the couple decided to investigate alternative fuels ... and were surprised to find that energy from wood — in the form of vapors produced under controlled burning conditions — could indeed power a vehicle and would require a minimum of engine modification. After doing some research, the Nunnikhovens fabricated a wood-gas generator for their delivery truck ... and they’ve been using the vehicle as a working “guinea pig,” to test performance and various designs, over the past several months.

Here’s how the Iowa couple’s wood gasification system operates: The wood scraps — pieces ranging from one to five inches on a side — are contained in a four-foot-high, 18-inch-diameter hopper with one-eighth-inch-thick walls. The chamber is sealed except for an airtight fill lid and an adjustable intake draft control. Inside this drum is a cone-shaped stainless steel hearth that’s ventilated to allow interior convection. From the hop per a gas outlet pipe connects, in series, to a drop filter and a centrifugal canister. Then additional tubing routes the fumes through a water vapor separator and on into the engine compartment ... where they’re fed into the carburetor’s breather shroud through a manually controlled air mixer valve which regulates the amount of “atmosphere” in the blend for a proper ratio. (The Carb’s butterfly valve then governs engine speed, as usual.)³

Where There’s Smoke ...

The producer gas is formed under conditions of high heat and controlled “respiration.” As air enters the generator, the solid fuel within the hearth burns, releasing carbon dioxide and water vapor ... and at the same time “manufacturing” a hotbed of charcoal in the base of the generator. The gases are then drawn by engine vacuum through the glowing carbon coals, where a destructive distillation process breaks down the CO² and water into carbon monoxide and hydrogen ... a mixture which — along with nitrogen, a small amount of methane, some unconverted carbon dioxide, ash, soot and water vapor — forms the final “gengas” fuel. Of this chemical potpourri, only about 45 to 50 percent is combustible ... and some components (notably ash, soot particles and water vapor) must be filtered out to prevent poor performance and possible engine damage.

After the gaseous fuel is “scrubbed,” it’s mixed in a roughly one-to-one ratio with fresh air and used directly in the engine. The Nunnikhovens opted to set up a dual-fuel (gasoline/producer-gas) arrangement for convenience. To do so, they simply installed a solenoid-operated shut-off valve in their truck’s petrol line, and rigged it so that the switch stops the flow of gasoline to the carburetor whenever the air mixer valve is moved from the full-open position (which, of course, is always the case when the vehicle operates in the “gengas” mode).

roy_9
12/22/2007 5:05:04 PM

I am looking for more in formation on all wood gas fuel and any others I can run my work ruck that is a 460 ford 350 van help me I need to save money






mother earth news fair

MOTHER EARTH NEWS FAIR

Oct. 21-22, 2017
Topeka, KS.

More than 150 workshops, great deals from more than 200 exhibitors, off-stage demos, inspirational keynotes, and great food!

LEARN MORE