Boost Your Wind Powered Water Pump With Spring Power

If you use a wind powered water pump on your farm or homestead, you may be able to up the system's efficiency by attaching a big spring.

| March/April 1981

068 spring assisted wind pump - photo 1

The author's wind powered water pump did produce water, but not at the system's rated capacity because his improvised sucker rod was too heavy.


Folks who attempt to set up a wind powered water pump on a shoestring budget—as I did—may find that, after buying a gearbox, tower, cylinder, and well pipe, there's not much cash left over for a standard "sucker rod." That's what happened to me , anyway, and I had to make do with a substitute. So, after scrounging around, I bought a supply of inexpensive, used one-inch galvanized pipe.

Unfortunately, when I'd completed the system, I found that I wasn't getting anywhere near the rated capacity of the cylinder even in very high winds. I started asking around and, sure enough, discovered that using anything but a genuine sucker rod would add excess weight, thereby overloading the mill and decreasing its output. Simply stated, my galvanized pipe was too heavy.

At first It seemed there was no choice except to buy the "right" rod. However, used wind pumps are scarce and new parts are expensive, so I decided to hold off a bit.

Then, on a trip to Oklahoma, I talked to an old farmer who suggested that I mount a spring to help lift the pumping rod in lighter breezes. He claimed that such a booster can make a real difference in the amount of water a pump supplies. I decided that it was worth a try.

To begin, I chose the biggest spring I could find: an old garage door coil. Using an eyebolt, I connected one end of the spring close to the top of the tower the other end to my sucker rod substitute by means of an old tailpipe clamp and a turnbuckle. The turnbuckle is optional, since the spring tension can easily be adjusted by moving the clamp up or down on the rod.

The spring should be stretched out far enough to support the weight of the sucker pipe, allowing the energy your mill captures to lift only water. So, in order to balance the spring's load, I disconnected my makeshift rod from the gearbox by unbolting the jackshaft from the sucker rod. Common sense told me that when the rod dropped down the spring was too loose, and when the pipe rose the tension was too great. Once no motion occurred, I figured I was all set.

11/9/2008 2:26:07 PM

I'd like to know a lot about the extraction of water by wind Thanks

mother earth news fair


Oct. 21-22, 2017
Topeka, KS.

More than 150 workshops, great deals from more than 200 exhibitors, off-stage demos, inspirational keynotes, and great food!