Scarecrow Ideas: The Spinning Soda Bottle
Don't limit your scarecrow ideas to the traditional stuffed shirt on a wood frame. A spinning soda bottle might do the trick.
Scarecrow ideas needn't be complicated; this one is essentially just an upended soda bottle on a dowel rod.
PHOTO: MOTHER EARTH NEWS STAFF
There's probably nothing more annoying than spending months preparing and caring for your garden, only to have your crops robbed by a flock of flying marauders. Well, take heart, good people. If you're looking for scarecrow ideas, MOTHER EARTH NEWS is here to show you a humanitarian way of discouraging the inconsiderate birds while simultaneously recycling one of our "throwaway" society's biggest headaches: the soft-drink container.
Our gadget is nothing more than a two-liter extruded plastic soda bottle with vanes cut into it, inverted and fastened onto a 1/2 " wooden dowel. It's actually quite easy to make, and shouldn't take you more than 10 minutes to "slap together." Start by selecting a dowel or thin broomstick (between 1/2" and 3/4" thick and about 3 or 4 feet long), then sharpen one tip of It and—with the pole held upright—drill a 3/32" hole vertically into the other end.
Now bore a 3 /16" hole right through the bottom of the container (directly in its center), and enlarge the "face" of the opening (either with a countersink bit or by simply gouging out some plastic with a pocket knife). Next, fashion a set of wind vanes for your scarecrow by first drawing seven vertical lines a couple of inches apart around the circumference of the vessel, from the top of its black base section up to the point where the bottle just begins to taper. They should be about 4 1/2 inches.
With this done, merely slice into the bottle along these lines with a single-edge razor or a knife, then complete each individual wind fin by making 1" horizontal scores at the ends of each of the previous slits to produce seven "flaps", which can then be bent outward from the bottle at a breeze-snaggin' 65° angle.
And finally, slip the dowel through the neck of your new "thingamajig" and attach the pole to the container's base with a No. 5 x 3 /4" wood screw (be sure to leave the fastener slightly loose so that the "bearing" doesn't bind). Poke the pointed end of the stick Into the soil between your garden rows, and even the slightest whisper of wind will cause the scarecrow to spin, putting birds to flight or keeping them from alighting in the vicinity.
Mind you, now, we can't guarantee that our rotary "raven-router" will send your feathered problems packing every time, but we can promise that this simple dingus will work when the wind does. And, by making several of 'em, you might just solve one big "fowl" problem!