BUILD A ZAPOTEC STOOL
This shop project is simplicity itself and produces a danged useful sitter, including diagram and assembly instructions.
This shop project is simplicity itself, and produces a
danged useful "sitter".
RELATED ARTICLES
The first time you're presented with a homebrewed beer, you might feel a bit skeptical. After all, ...
You can buy sawhorses made of plastic, aluminum or steel. Or you can make your own. The simplest me...
Appreciating the role bees play in plant sustenance; volunteers on organic farms; powerful pruning ...
You've probably seen a tree trunk-type footrest before, in which case you don't need me to tell you...
by Dan and Madelyn Walker
If you've ever been stuck without a sturdy support to sit
on, you'll appreciate this simple stool . . . based upon a
design that's been used, for ages, by the Zapotec Indians
of southern Mexico. To make one, round up a five-foot
length of 1 X 12 (old shelving is fine), 16 four-penny
finishing nails, some white or yellow carpenter's glue, a
ruler, a protractor, and a saw.
Start by cutting the board into two 14" and two 16"
lengths, then trim a V-shaped 135° notch in one end of
each 14" section as shown (you can also remove a decorative
3-1/4" X 3-1/4" X 5" wedge from the opposite end of the two
components, if you wish). Next, from each of your remaining
two pieces of lumber, cut two (lengthwise) parts: the first
6-1/2" wide . . . the other only 2" wide and lopped down to
14" in length. Now place one of the 6-1/2" X 16" seat
halves, temporarily, into position on one slope of the
V-notch, and mark the inside edge of the slanted board so
you'll be able to trim off an appropriate-sized sliver (in
order to allow the plank to meet its "mate" smoothly).
Repeat the process with the other seat portion to complete
the mitered V-joint ... then fashion two 3/4" X 2" notches
in each of the stool's leg planksmidway between top and
bottom—to accommodate the struts.
With all the pieces trimmed to size, assemble your project
by simply "whitegluing" the parts together and securing
them with finishing nails, as illustrated in the drawing.
(Yes, the seat is supposed to extend beyond the legs
slightly!) After giving it a light sanding, you'll find
that this very uncomfortable-looking stool is actually a
pleasure to sit on . . . because the handmade hassock was
designed with the behind in mind!