During the 1981 Future Fuels Rally, competitors raced across the country in experimental vehicles with alternative fuels, such as ethanol, wood gas and more.
MOTHER EARTH NEWS' wood-burning truck, which made the trek across the country.
PHOTO: MOTHER EARTH NEWS STAFFRegular readers of this publication are no doubt aware that members of MOTHER EARTH NEWS' research crew spent a great deal of time and effort preparing both our wood-burning truck and our ethanol-powered van for the Los Angeles to New York City "Future Fuels Rally" sponsored by Shepard Electronics, Inc. of Rochester, New York.
Well, the big event was held during the week of October 17-24 in 1981. Though there were — as could have been predicted in an undertaking of this magnitude — a few disappointments along the way, 20 vehicles rolled into the Big Apple powered by just about everything but petroleum!
As with any competitive affair preceded by ballyhoo and huzzahs, there were a lot more people who talked about participating than there were folks who actually paid their entrance fees. But, when the green flag dropped, 38 entrants pointed their vehicles east and bade farewell to the City of Angels en route, through nearly two dozen checkpoints, to New York City (via Arizona, New Mexico, Colorado, Nebraska, Illinois and Ohio).
Unfortunately, a number of occurrences marred what could have been a fairly smoothly run event. To begin with, the size of the purse (at one point said to total $300,000) was held in question just days before the rally . . . putting a burden on many people who'd made financial sacrifices in the hopes of recouping their expenditures in the end. Then, in Los Angeles, it was indicated that the procedure by which the various wood fuels' BTU values were to be measured (there were four wood-powered entries) would be changed, which many felt, worked to the disadvantage of the liquid-fueled vehicles, whose rates of consumption were being measured very accurately. To make matters worse, a tragic accident just outside Phoenix left rally coordinator David Carmichael badly injured and very nearly shattered the contestants' hopes of continuing the rally according to plan.
Despite the setbacks, however, the show did go on. An impromptu "yea or nay" conference, held in Albuquerque by the drivers left in the group, settled any doubts as to the future of the race: "We're going to New York, rally or not!"
As we mentioned earlier, there were four wood-powered entries (MOTHER EARTH NEWS' included), and the coast-to-coast journey provided an excellent opportunity for the biomass-burners to compare notes and give their machines a nearly nonstop "do or die" acid test under a variety of climatic conditions. There were also diesel-engined contenders and the drivers of those vehicles (among them a turbocharged Peugeot-engined Jeep) used various kinds of vegetable oils to power their creations. (Future Fuels Challenger Doug Malewicki — designer of the California Commuter featured in the Experimental Vehicle Newsletter — fitted his highly aerodynamic tri-wheeler with a 6.4-horsepower Lombardini diesel engine supplied by MOTHER EARTH NEWS' researchers and managed to squeeze an average of 145 miles from each gallon of specially blended fuel. Since Doug's car was an unofficial entry, however, he left the rally at Phoenix, having proved his point.)
At the time of this writing, the Future Fuels Rally sponsors have not yet declared an overall winner, pending the calculation of a vehicle-weight-IBTU-consumed ratio for each entry, which is a figure that most contestants agree — given the less-than-perfect conditions under which the event was held — will likely be an educated estimate at best.
At any rate, whether there's one victor or 20, the members of MOTHER EARTH NEWS' research crew (B.V. Alvarez, Robyn Bryan, Norman Holland, Don Barrett and John Vogel) learned some valuable lessons from their experience with the ethanol-fueled van, the woodburning pickup (which, by the way, utilized a dual-fuel carburetor with alcohol as the reserve source of energy), and our ethanol-powered Ford truck, which went along to rack up some more test miles and to serve as a fuel carrier.
Here are the facts: Both alcohol-powered vehicles performed exceptionally well, save for a minor filter problem on the Ford. (It was a blessing in disguise actually, because it forced us to use a different type of filter — a corrugated undersink, paper-element, water-straining cartridge — which, as it turned out, performed better than anything we'd tried previously.) Furthermore, the trip allowed us to chalk up some final observations on the recent camshaft modifications that we'd made to enhance the alcohol-powered vehicles' performance during off-idle and mid-range operation.
In a nutshell, the best-behaved cam, measured at 0.010-inch tappet travel, had the following specifications: Intake valve open at 6 degrees "Before Top Dead Center" and closed at 41 degrees "After Bottom Dead Center" exhaust valve open at 57 degrees "Before Bottom Dead Center" and closed at 3 degrees BTDC and a lift of 0.425 inches for both the intake and exhaust valves.
As far as our wood-burning vehicle was concerned, our lessons were even more rewarding. Besides finding out that wood smoke and ethanol make perfect companion fuels (both are slow-burning, perform best under high compression and with advanced timing, and thus function well in the same engine), we learned that certain kinds of wood — such as the ponderosa pine commonly found on the West Coast — don't compare favorably with our old standbys, scrap yellow pine and oak, because of the western wood's high ash content and low gas quality. In fact, at the start of the trip, the research crew had to fabricate a larger filter to contend with the increased amount of ash created by the inferior fuel. But even with these last-minute problems, the 454-cubic-inch Chevy-working at a 12-to-1 compression ratio and capable of traveling at speeds up to 80 MPH-covered upward of 100 miles on each of its 150-pound fuel loads before stopping for a refill.
Later on in the trip, in the cold climates of Denver and Omaha, excessive condensation proved to be another bugaboo, since it shortened the intervals between necessary filter cleanings. We're currently designing a centrifugal extractor that should eliminate this problem.
All in all, we've concluded that our time and effort were well spent — if not because we'll reap an outright reward, then at least because we helped to prove that alternative fuels aren't merely a pipe-dreamer's fantasy.
With more than 150 workshops, there is no shortage of informative demonstrations and lectures to educate and entertain you over the weekend.LEARN MORE