If you use a wind powered water pump on your farm or homestead, you may be able to up the system's efficiency by attaching a big spring.
The author's wind powered water pump did produce water, but not at the system's rated capacity because his improvised sucker rod was too heavy.
PHOTO: EDWARD BURLBAW
Folks who attempt to set up a wind powered water pump on a shoestring budget—as I did—may find that, after buying a gearbox, tower, cylinder, and well pipe, there's not much cash left over for a standard "sucker rod." That's what happened to me , anyway, and I had to make do with a substitute. So, after scrounging around, I bought a supply of inexpensive, used one-inch galvanized pipe.
Unfortunately, when I'd completed the system, I found that I wasn't getting anywhere near the rated capacity of the cylinder even in very high winds. I started asking around and, sure enough, discovered that using anything but a genuine sucker rod would add excess weight, thereby overloading the mill and decreasing its output. Simply stated, my galvanized pipe was too heavy.
At first It seemed there was no choice except to buy the "right" rod. However, used wind pumps are scarce and new parts are expensive, so I decided to hold off a bit.
Then, on a trip to Oklahoma, I talked to an old farmer who suggested that I mount a spring to help lift the pumping rod in lighter breezes. He claimed that such a booster can make a real difference in the amount of water a pump supplies. I decided that it was worth a try.
To begin, I chose the biggest spring I could find: an old garage door coil. Using an eyebolt, I connected one end of the spring close to the top of the tower the other end to my sucker rod substitute by means of an old tailpipe clamp and a turnbuckle. The turnbuckle is optional, since the spring tension can easily be adjusted by moving the clamp up or down on the rod.
The spring should be stretched out far enough to support the weight of the sucker pipe, allowing the energy your mill captures to lift only water. So, in order to balance the spring's load, I disconnected my makeshift rod from the gearbox by unbolting the jackshaft from the sucker rod. Common sense told me that when the rod dropped down the spring was too loose, and when the pipe rose the tension was too great. Once no motion occurred, I figured I was all set.
Remember that if your pump has the normal eight-inch stroke, you'll want a spring that—at rest—is at least double that length so it'll exert a more even force through the stroke. (Garage door springs are usually ideal.) Folks with exceptionally deep wells might want to use more than one spring. If you do, be sure to space them equally around the tower to keep the rod centered.
Before I Installed a booster, my pump was producing approximately three gallons per minute in a stiff breeze. With the added spring power attachment my system's per-minute flow has increased to four gallons!
It was an easy modification that certainly paid off for me, and I'm sure other people with "make do" sucker rods on their wind powered water pumpers will find this project to be well worth the effort, too.
With more than 150 workshops, there is no shortage of informative demonstrations and lectures to educate and entertain you over the weekend.LEARN MORE