Mother’s Folding Sawhorses

1 / 3
Workman using the folding sawhorses for a drywall-cutting project.
Workman using the folding sawhorses for a drywall-cutting project.
2 / 3
A finished sawhorse will look something like this. 
A finished sawhorse will look something like this. 
3 / 3
Parts and assembly diagram of a folding sawhorse.
Parts and assembly diagram of a folding sawhorse.

When you need to cut up a batch of lumber — whether it be plywood or studs — there’s just no substitute for a sturdy pair of sawhorses. Unfortunately, until that moment arrives, the four-legged stands seem to be forever in the way of whatever project you’re working on. The fact is that — even if they’re stacked, hung, or stored on end — assembled sawhorses take up a lot of valuable space.

MOTHER EARTH NEWS’ own Emerson Smyers was confronted with just such a problem in his workshop and decided to solve it by designing a set of folding sawhorses, which can be stored snugly against the wall when not in use. The wooden “steeds” that resulted from our research director’s dilemma work like a pair of scissors which — when locked into position — firmly clamp a 2 X 4 crosspiece. Then, once your cutting job is done and a homemade hinged bracket on the sawhorse is released, each pair of legs will collapse to a size barely larger than a single 2 X 4!

Of course, building a folding sawhorse is slightly more complicated than tacking together a standard cutting stand, but the construction can still be accomplished using basic tools — including a handsaw, a saber saw, and a drill with a 1/4″ bit — and a minimum of materials. For each horse you’ll need to collect only an eight-foot length of 2 X 4, 30 inches of 1/8″ X 3/4″ steel strap, a foot of 1/4″ cold-rolled steel rod, two 1/4″ X 1 ” machine screws with nuts, a 2″ X 4″ piece of 16-gauge steel, and a small piece of 100-grit sandpaper.

Begin construction by dividing the 2 X 4 into two 31″ lengths (from which the legs will be formed), leaving a 34″ section for the crosspiece. Next, rip each of the 31″ boards down the 3 1/2″ dimension to produce four approximately 1 1/2″square legs. At this point, you can trim one end of each support at a 75° angle so it will rest flush with the floor when in use, but don’t trim the other end until later in the construction process.

The sawhorse legs are connected in two places — at points 3 1/4 inches and 11 1/2 inches from the top of each 1 1/2″ square section — with brackets formed from 1/8″ X 3/4″ steel strap and held in place by 1/4″ steel rod. While the upper connection is a single 4″-length of metal, the lower bracket is formed from two 5″ pieces that are overlapped and bolted together — with a 2″ X 2″, 16-gauge steel stop folded over the pivot and sandwiched by the bolt and nut — to allow the legs to open and lock into position.

Comments (0) Join others in the discussion!
    Online Store Logo
    Need Help? Call 1-800-234-3368