Make a Fireplace Water Heater

If you know a little about plumbing, you can make this fireplace water heater and capture more of the heat that otherwise would disappear up your chimney.
By Lyman D. Schwartz
November/December 1978
Add to My MSN

The grate is actually a fireplace water heater—a network of pipes through which circulating water picks up heat and carries it to other parts of the Schwartz home and TV shop.

Content Tools

Related Content

30 Steps to Energy Efficiency – Step 16: Clean Out Your Refrigerator Coils

It might seem like a small thing, but your refrigerator can be a HUGE drain on your energy bill. We’...

3 Methods for Heating Greenhouses for Free

Smooth out the temperature range in your greenhouse by adopting one of these strategies for heating ...

What Is a Solar Hot-Air Collector?

You can use a solar hot-air collector to heat your home with renewable energy. Here’s more about how...

How to Keep Livestock Water from Freezing

Our Facebook fans gave us feedback on how to keep livestock water from freezing when the weather get...

We pretty much run our fireplace day and night during the winter. With heating costs as high as they are today, I hated to see all that warmth going up the chimney. So I set out to do something about using some of the "wasted" heat.

The solution that I came up with is inexpensive, fairly simple to put together, and darned effective, too! I built a fireplace water heater. It's a grate made of 1" (internal diameter) black pipe through which I run water from a 75-gallon storage tank, right under the glowing coals. The system uses an electric circulator, which operates continuously while the fireplace is in use. I also installed a backup circulator, powered by a standard 12-volt auto battery, that kicks in automatically if the electricity goes off—as it frequently does during our Gettysburg, Pennsylvania winters.

This setup gives me approximately 80 gallons of hot water, which I feed through another circulator into 55 feet of baseboard heater in my hard-to-warm, north-facing, 20' x 34' TV shop ... and into another 10 feet of baseboard that runs along our home's central hallway.

The kitchen and living room get their heat from the well-insulated, blower equipped, "Heatilator" fireplace itself, and the bedroom stays at a comfortable-for-sleeping 58° to 80°F with no heat other than the overflow from the other rooms. To keep the house cozy all night long, I fill up the fireplace once before I go to bed, and again between 2:30 and 3:00 a.m. My standard hot-air furnace will, of course, come on if things get too chilly in the wee hours, but the house hardly ever gets cold enough to make that extra (more expensive) heat necessary.

I also installed a thermocouple and a pyrometer heat meter in my system, so I'd be able to check the temperature of my "stored" water at any time. The meter is capable of reading up to 250°F, and my storage tank's water averages around 130 degrees. (I've actually gotten it as high as 195 degrees on several occasions, but that requires one heck of a hot fire!)

Once I had this whole system worked out and was telling myself how good it was, I got another brainstorm. "You dummy," I said to myself, "you've got 80 gallons of hot water on hand just about all winter long. Why not put two domestic heating coils in that 75-gallon storage tank and preheat the water for your electric water heater?" Well, I did just that, and I'm plenty pleased with the results. Whether the water in our "fireplace" tank is 150 degrees or 100, we still get the benefit of that bonus heat. This means that the electric water heater doesn't have to run as much, because the water that flows into the appliance has already been warmed on its way through the heating coils in my storage tank.

And just how well does my fireplace-powered system work? Well enough to heat my 34' x 70' house/shop combination all winter long with only 110 gallons of fuel oil and 11 cords of wood. That's not bad, especially when you consider that an average winter here in our part of Pennsylvania means outside temperatures that stay down around twenty degrees Fahrenheit for months on end!

Post a comment below.


Doug Smith
1/23/2009 2:24:27 PM
I could not do this as my house is over 100 feet long and around 50 feet wide at it's widest. I have a fireplace upstairs and one downstairs in the basement, but they just end up sucking air from other parts of the house. I am looking into adding inserts for greater efficiency. I am using glass doors, but this sends way more heat up the chimney than into the room. I can also tell you that those metal screens that you put in front of your fireplace to keep the sparks off the carpet block a substantial amount of heat also. I like the idea of the pipe, and maybe two large 50 gallon or so copper tanks on each side of the fireplace to hold the heated water. If you were to have an inlet and outlet then you could get a thermosiphon going, and eliminate the need for the circulator.

1/2/2008 2:41:24 PM
hi i was reading this i wood like to see pic or send me more about it tym

Subscribe Today - Pay Now & Save 66% Off the Cover Price

First Name: *
Last Name: *
Address: *
City: *
State/Province: *
Zip/Postal Code:*
(* indicates a required item)
Canadian subs: 1 year, (includes postage & GST). Foreign subs: 1 year, . U.S. funds.
Canadian Subscribers - Click Here
Non US and Canadian Subscribers - Click Here

Lighten the Strain on the Earth and Your Budget

MOTHER EARTH NEWS is the guide to living — as one reader stated — “with little money and abundant happiness.” Every issue is an invaluable guide to leading a more sustainable life, covering ideas from fighting rising energy costs and protecting the environment to avoiding unnecessary spending on processed food. You’ll find tips for slashing heating bills; growing fresh, natural produce at home; and more. MOTHER EARTH NEWS helps you cut costs without sacrificing modern luxuries.

At MOTHER EARTH NEWS, we are dedicated to conserving our planet’s natural resources while helping you conserve your financial resources. That’s why we want you to save money and trees by subscribing through our earth-friendly automatic renewal savings plan. By paying with a credit card, you save an additional $5 and get 6 issues of MOTHER EARTH NEWS for only $12.00 (USA only).

You may also use the Bill Me option and pay $17.00 for 6 issues.