The Hawaiian Influence on the Slide Guitar
Although the Hawaiian people have long possessed a great musical tradition, its focus — up to that time — had been on vocals often with some drum and seashell accompaniment. Guitars, however, had been brought to Hawaii by Mexican and Portuguese settlers and, with Kekuku's discovery to inspire them (and the later development of the technique to instruct them), the islanders soon took to tuning those instruments to an "open" or "sung" chord. This style of tuning — which is known as slack key because some strings are turned down from the standard tension to achieve the open chord — simplified both the chording process and the task of tuning by ear. When a guitar is tuned to an open chord, you see, a person can simply lay one finger straight across the fret board to achieve a major chord. This allows the player to slide a steel bar up and down the neck of the instrument to create different chords and sliding notes . . . resulting in sounds that remind many folks of palm trees swaying in a tropical breeze!
The new Hawaiian guitar eventually supplanted the musical saw in most of the dance orchestras of the '20s. Later its sound, as produced by the pedal steel guitar, went on to become a trademark of modern country music.
An Evolution of Sounds With the Dobro Guitar
Now, it just so happened that the introduction of the Hawaiian steel guitar (or dobro) style coincided with a number of technological breakthroughs in the recording industry. The combination contributed to a musical craze that swept the nation. Jimmie Rodgers — known to many as the "father of country music" — used a dobro player in many of his recordings, and his yodeling and slide guitar sound soon found their way into the dance band music of Texas and Oklahoma. This eventually became known as western swing.
Leon McAuliffe, a steel player for Bob Wills and the Texas Playboys, began his professional career with a dobro but later switched to the electric steel guitar that was developed in the '30s. The Hawaiian music fad began to slow down in the '40s, but by then the steel guitar sound had a strong foothold in country music, with men like Brother Oswald (in Roy Acuff’s band) and Jimmie Helms (in the Hank Williams group) heavily influenced by the Hawaiian guitar virtuosos.
Benefits of the Slide Guitar
First (of course) find an old lap guitar (check out "junk" stores and basement or garage sales). Or you might, instead, use a standard guitar that has a warped neck or that is, for some other reason, less than perfect for ordinary playing. In the latter case you'll need to purchase a nut raiser or make a higher nut that has a flat top. You'll want the surface of the string plane as flat as possible, too, though many steel-string guitars (don't use nylon strings for slide playing) have arched fret boards with strings arranged over them.
There are two sorts of "ready-made" bars available commercially for use with a slide guitar. One, called a bullet bar, is simply a heavy steel cylinder with a rounded end. The other type, known as the Stevens bar, has indentations on each side and on top, which make it easier to hang on to. (Of course, if you've already located a suitable guitar, you don't need to visit the music store before trying your hand at slide playing. As I mentioned before, early players used pocket knives, metal combs, the handles from kitchen cutlery — and assorted other objects — as bars.)
Playing a Slide Guitar
The original slack-key system also allowed a D tuning. In this one — D A D F# A D — all but the fourth and fifth strings are lowered and heavier strings may be necessary. A parallel tuning can be accomplished in D, too, which would change it to F# A D F# A D. In this manner you can play the same passage high or low without changing positions, which can come in very handy.
If you should happen to find an old Hawaiian guitar book in a used book shop or a secondhand store, a few of the commonly used tunings will probably be given in the opening pages. Such original tunings often produce a better sound when raised a whole step. That results, for example, in an A tuning of E A E A C# E, and an E tuning of E B E G# B E. Those of you who'd like to get a bit fancier may want to try these three additional tunings: (E7) B D E G# B E, (C#M7) E B E G# C# E, or (C6) C G E A C E. (In all cases the tunings are listed starting with the sixth — or lowest — string.)
Most Hawaiian guitar and dobro musicians fingerpick, using picks on the thumb and two fingers. Some guitarists —Tut Taylor, for example — flat pick in lap style, while I finger pick, using three fingers and my thumb (an adaptation from my regular guitar-playing style). I suggest you use whatever technique works best for you.
You'll also want to experiment with the various tunings I've given you and any others you find or invent. Many players do use more than one, either by simply retuning or by having a second instrument on hand. Keep in mind that if you've converted a standard guitar into a "slider," it's important to keep an eye on the amount of tension you put on the instrument when tightening the strings. (Of course, assuming that you use a guitar built for steel strings, most potential problems can be avoided with proper string gauging.)
Developments in Slide Guitar Performance
If you'd like to try this technique, commercially produced glass and steel bottleneck slides are available, but of course it's possible to manufacture your own from any of a variety of materials. Look for a bottle with a long, straight-sided neck. Then sever the neck by scoring it with a triangular file along a line at the desired length and tapping it firmly just below that line. (Naturally, a bottle cutter would also do the trick.) Grind all sharp edges down. Be certain to wear safety goggles any time you work with glass.
If your toolbox houses a wrench with a deep socket that fits your little finger, that tool can provide a good ready-made substitute for a bottleneck. In fact, any kind of metal tubing — particularly stainless steel or hard brass — can be used to produce a solid, hefty sound.
ACCESS HAWAIIAN STYLE
Frets magazine runs a regular column by Mike Auldridge — dobroist extraordinaire — and Frets has a sister publication called Guitar Player, which contains Rusty Young's column on pedal steel playing.
I've also come across several albums featuring slide guitar that would be good additions to anyone's collection: Steel Guitar Classics, Hawaiian Guitar Hotshots, Robert Gear — Steel Guitar and Dobro and Hula Blues.
I hope I've inspired you to at least give this unusual form of old-time guitar pickin' a try. Beginners can take encouragement from the fact that "sliding" is much easier to master than playing fret chords. You'll also find that picking along with someone else — even if that "someone" is on the radio or a record — will speed up your learning.