We devised this sawbuck to cut our smaller firewood. I took an 8-foot, 2-by-6-inch board and cut a 45-degree bevel on both sides to make the ramp. I used two 8-foot, 1-by-4-inch boards to make the sides and I attached them to the base with deck screws. I then sunk two 4-by-4s into the ground and cemented them into place. I cut the tops of the 4-by-4s to a comfortable cutting height, and angled the cut for a downward slope. I used 3-inch deck screws to attach the ramp to the top of the posts.
We mark our firewood to fit our woodstove’s capacity. I make marks on a straight stick with a logging crayon every 16 inches, using electrical tape as a guide. My wife slides the marked logs down the ramp, and I cut them off using an electric chainsaw. This sawbuck setup saves a lot of time and backbreaking, unnecessary work.
Fort Garland, Colorado