Convert Your Backpack to a Child Carrier

Enjoy the outdoors with your tot in tow.


| July/August 1984



088-150-01i2

This project leaves your pack intact for normal carrying, too.


PHOTO: MOTHER EARTH NEWS STAFF

Are you a hiking parent faced with the problem of what to do with Baby while you trek the wilds? It seems that a lot of folks who don't have access to grandparents—or to other free, long-term baby-sitters—often just resign themselves to non-backpacking lives until their young sprouts are big enough to tag along under their own steam. At least, that's what my husband and I were on the verge of doing ... when we figured out an easy, inexpensive way to convert a frame backpack to perform double duty as a child carrier for our son.

Nowadays, our young'un rides comfortably and safely in the top portion of my pack, with his legs dangling through special openings, while the pack's bottom and side pouches still tote camping gear. In fact, I've found this arrangement to be so handy and comfortable (for me, as well as my tot) that I even use it for running around-town errands. I can carry my child and my purchases on my back, and be free of the hassles that usually go with trying to shop and keep track of a toddler simultaneously.

Making the Child Carrier 

The conversion takes only a few minutes and an investment of about $3.00 ... and it leaves your pack virtually unharmed for "normal" (that is, non kid) carrying. But in order for this alteration to work, you'll need an external-frame pack that has two main compartments in back ... an upper and a lower. Luckily, since this two-pocket arrangement is a fairly common style for this type of carrier, you shouldn't have trouble locating one (if you're not already so equipped). Your child will be riding on the base, or "floor" of the upper compartment, with his or her legs dangling in toe-wiggling freedom through slits cut into the pack material and reinforced with Velcro-type tape.

All that's required—besides a pack and a child, of course—is a 2"-wide strip of the self adhering tape, about 18" long (measure the width of the back of your pack to determine the exact length of the strip you'll need).

Separate the two sides of the tape, and sew the portion with the soft, fuzzy surface horizontally across the outside of your carrier, aligned just above the base of the top compartment. Remove the pack from its frame and sew the edges of the strip securely to the sack's material.

Now mark the horizontal center point of the tape and then start your leg-slit measurements an inch or two on either side of the mark (as shown in the Image Gallery). Next, draw a straight line about 6 inches long for each of the leg openings, and zigzag with your machine—or hand-sew—securely around the marks to insure that the material doesn't rip or unravel.





Crowd at Seven Springs MOTHER EARTH NEWS FAIR

MOTHER EARTH NEWS FAIR

Sept. 15-17, 2017
Seven Springs, PA.

With more than 150 workshops, there is no shortage of informative demonstrations and lectures to educate and entertain you over the weekend.

LEARN MORE