The following is an excerpt from The Complete Guide to Sausage Making by Monte Burch (Skyhorse Publishing, 2011). Learn how to butcher meat and how to make sausage using this guidebook, complete with several easy-to-follow recipes for dozens of sausage variations. This excerpt comes from Chatper 3, “Food Safety.”
My favorite method to butcher a deer for sausage making these days is to bone off all meat while the deer carcass is still hanging. This prevents the possibility of contamination from pathogens found in the brain and spinal column when cutting through them with a meat saw. This results in a pile of boneless meat, the loins going into the freezer for steaks, and the rest to be ground “burger” or for sausage making, with some used for jerky as well.
How to Butcher a Deer
To begin butchering a deer, the carcass should be hanging head down. The first step is to skin the carcass (if not already done). I like to use a rope winch to lower or raise the carcass as I work on the different areas. The skin can be removed with or without cutting off the head and front feet. One method is to skin down to the head and cut it off at the neck, then skin down to the front feet and cut them off with a meat saw. Or skin down to the head and cut off the skin at the joint between the head and neck. Cut from inside the skin to help prevent getting hair on the carcass. Skin down to the hocks and encircle the legs with a cut to remove the skin from the legs. The latter avoids using a meat saw completely, but it requires a bit more skinning effort.
Using a good, sharp boning knife, separate a front shoulder from the carcass. There is no connecting bone joint between the shoulder and the body. Simply pull the front leg out and away from the carcass and slice it off. Lay this shoulder aside and remove the other.
Again, using a good boning knife, simply cut all the deer meat away from the shoulder bone and leg.
The bottom portion of the leg is filled with sinew and is quite tough. I usually add this to another pile to be used as “dog food” (cooked first) for our Labs, but it can also be ground with a sharp grinder. Note: There is a sharp ridge of bone on the outside of the shoulder that must be cut around to obtain all the meat from the side.
Place these boned-out deer meat pieces in a clean, covered tub and refrigerate until you can grind them.
Remove the backstrap or loin by cutting down either side of the backbone, then cutting from the rib side to release the long strip of meat. Properly cut, the loin will peel out fairly simply. Cut away the other backstrap in the same manner. This choice piece of meat can be ground for sausage, but we find that it’s just too tasty to eat it grilled. Don’t forget to cut and peel the small tenderloin pieces located inside the carcass next to the backbone. Cut away the brisket meat, as well as the layer of meat joining the ribs and the backbone. Then simply cut away all neck meat, leaving the neck bone. This is tougher meat that requires the use of a consistently sharp knife. Although my nephew bones out the meat between each rib, I find this meat has a lot of fat, which must then be trimmed away when grinding, so I usually leave it in place to be discarded with the carcass.
The hams or hindquarters provide the most deer meat for sausage making and are also boned out while the carcass is still hanging. Don’t worry about keeping specific pieces separate, such as you would do with labeled, traditional butchering. If there was any spillage of intestinal fluids around the aitch bone or anus area, it would be on the exposed ends of the hindquarters next to the bone. Trim these pieces away, and then wash and sterilize the knife. Make a cut starting at the top of the hindquarter and simply follow the bone down to the aitch-bone area. Make a cut down the aitch bone to meet the first cut, then continue cutting around the bone until you have removed all of the meat.
Now you are left with a completely boned-out deer carcass and a good amount of boneless deer meat ready to grind for sausage making. And there are no bones to take up excess space in your refrigerator or freezer.
Again, these boned-out pieces must be kept well refrigerated until they can be ground for sausage. Do not wait overly long, as even refrigerated meat will spoil. Cut up or grind within three days. Actually, it is suggested that you freeze the meat at 0 to 5 degrees Fahrenheit for sixty days, which will kill most pathogens, except trichinosis in bear meat and hogs.
Preparing Deer Meat for Sausage Making
The next step is to cut the meat into chunks to be ground. On deer it’s important to cut away all the fat and as much gristle and sinew as possible. The former doesn’t create a safety problem, but fat in deer adds an “off” taste. The amount of fat trimmed away from beef and pork depends on the type of sausage and your taste preferences. An excess of beef suet can also create an off taste. Trim away all gristle and sinew, as it makes the meat tough, and make sure you cut away all bloody meat parts and discard them. Always thoroughly wash your hands both before and after you handle raw meat. Do not use cutting boards for both meat and other foods, but keep meat-only boards. Clean and sanitize cutting boards often.
Other important safety steps must also be followed:
- Keep meat and poultry refrigerated below 40 degrees.
- Use or freeze ground beef and poultry within two days; whole red meats, within three to five days.
- Defrost frozen meat in the refrigerator, not on the counter.
- Marinate meat in the refrigerator, and discard marinades; do not reuse.
Cooking, Drying, and Smoking Sausage: Food Safety Basics
Sausages are basically fresh (uncooked), dried, or cooked. Many of the dried or cooked sausages may also be smoked. Fresh or uncooked sausages must be cooked to an internal temperature of 160 degrees. (or 165 degrees for poultry meat) before consuming. When making cooked sausages, such as frankfurters, they should be cooked after stuffing to an internal temperature of 160 degrees. (165 degrees for those containing any poultry).
Dry sausages, such as summer sausages or pepperoni, have traditionally not been cooked but are dried. This is where things get a bit confusing. These sausages actually consist of two categories, both dry and semidry sausages.
According to the USDA Fact Sheet on Food Safety:
Any of the sausages may be smoked for flavor, and some are smoke-cooked as well. Sausages, regardless of the type, must be considered raw or fresh unless they have been heated to an internal temperature of 160 degrees. For instance, some recipes call for smoking at 100 degrees for several hours. This is not a heat treatment but smoking. Regardless of whether you are smoking or drying, the recipes in this book call for a heat treatment of the required internal temperature of 160 degrees (or 165 degrees for sausages containing any poultry).
Smokers that can achieve the desired temperatures, and maintain the temperatures properly, should be used. Smoking can also add more flavor to the jerky. Electric smokers with adjustable temperature controls up to 275 degrees or over are a good choice. Use only proper smoking wood or chips, such as apple, hickory, alder, or mesquite. Softwoods such as pine contain resins and compounds that not only provide an off flavor but are also dangerous.
Reprinted with permission from The Complete Guide to Sausage Making, published by Skyhorse Publishing, 2011.