Home Tanning Process Preserves Pelts

Article Tools

Image Gallery

Print

E-mail

Comments

RSS

This recipe makes enough tanning solution to tan four large animal skins; or ten rabbit skins; or about six medium-sized pelts such as groundhog. (Cut the recipe in half for fewer skins).

MIXING THE SOLUTION

A couple of hours before you plan to tan, soak the dried skins in clear, fresh water until flexible. Boil three gallons of water and pour over the bran flakes. Let this sit for an hour, then strain the bran flakes out, saving the brownish water solution. Next, bring the remaining four gallons of water to a boil. Put the 16 cups of salt in a plastic trash can. Pour the water over the salt and use the stirring stick to mix until the salt dissolves. Add the brown bran liquid. Stir.

When this solution is lukewarm, you are ready to add the battery acid. Read the warning label and first aid advice on the battery acid container. While wearing gloves and an old, long-sleeved shirt, very carefully pour the battery acid down the inside of the trash can into the solution - don't let it splash. Stir the battery acid in thoroughly.

At this point, you can peel off the hide's dried inner skin. If you have fresh skins, use as is. Add the skins to the solution and stir, pressing the skins down carefully under the liquid until fully saturated. Leave them to soak for 40 minutes, stirring from time to time to make sure all parts of the hides are exposed to the solution. During the soak, fill your other trash can with clear, lukewarm water. After 40 minutes, soaking is complete. Use the stirring stick and carefully move the skins one by one into the other trash can. This is the rinsing process, which removes the excess salt from the skins. Stir and slosh the skins for about five minutes, changing the water when it looks dirty.

At this point, some people add a box of baking soda to the rinse water. Adding baking soda will neutralize some of the acid in the skin - this is good because there will be less possibility of residual acid in the fur to affect sensitive people. However, this also may cause the preserving effects of the acid to be neutralized. You need to make the choice to use baking soda based on your own end use of the skin. If skin or fur will spend a lot of time in contact with human skin, I'd use the baking soda. If the pelt will be used as a rug or wall hanging, I probably wouldn't.

RSS | Comments | E-mail | Print