AUTO AIR CONDITIONING

Article Tools

Image Gallery

Print

E-mail

Comments

RSS

The Basic Parts

Though there are several ways to lay out the components of an auto air conditioner, you'll always find five essential parts. A typical layout is shown in Fig. 1. In order to troubleshoot your system, you'll have to be able to identify the components and have some idea what they do:

1. Compressor. The compressor takes low-pressure, cool refrigerant and makes it hot by compressing it. Two to six pistons that resemble the ones in your engine do the actual compressing. A V-belt from the engine drives the unit, and a clutch on its front disconnects it when the air conditioner is switched off. (Some systems cycle the compressor on and off to control the temperature inside the car. In these, the clutch is wired to the on/off switch and a thermostat.)

The compressor should be easy to find. Look for a comparatively large object with a pulley and fan belt, two rubber hoses about an inch in diameter, and valves on top that look like the ones on your tires. When you find it, track down the compressor clutch wire (there should be only one wire going to the compressor), and see if there's a fuse inline nearby. If so, note its rating, and buy a replacement to keep as a spare in the glove compartment.

2. Condenser. The condenser removes heat from the high-pressure refrigerant gas, enough to cause the gas to condense and become a liquid. This is possible at a comparatively high temperature because the pressure is high at this point in the system. Look in front of the car's cooling-system radiator, and you'll probably find another radiator-looking thing. You can confirm that it's the condenser (rather than a transmission or oil cooler) by tracing a hose connected to its top back to the compressor.

Called the "high side," the section between the compressor and the expansion valve may see pressure as high as 270 psi. Hoses in this section will be subject to more rapid deterioration than those on the "low side," though both sets bear inspection.

3. Receiver-drier. Once the refrigerant turns into a liquid, it's stored in the receiver until needed. While there, it passes through a filter to remove dirt and through desiccant to remove water. (It's very important that the refrigerant stays dry. It combines readily with water to form hydrochloric acid, which would corrode the metal pans of the system.)

There's a good chance that the receiver-drier will be near the condenser. Track it down by following the hose that comes out of the bottom of the condenser. You'll know you've found the right can-with-hoses when you locate one that has a roughly half-inch viewing window near its inlet. This is called the sight glass. When the air conditioner is operating, you should see clear liquid inside. If it's milky, you've got water in the system; if it's frothy or bubbly, there's air in there. Both conditions require the attentions of a qualified service person.

RSS | Comments | E-mail | Print