A 2? SHOWER-HEAD FLOW LIMITER
(Page 2 of 2)
The next step is as tough as this project is going to get.
Using a pair of snips, cut a number of little wedges
— all the way around the rubber disk — from the
outside of the circle and not quite to its center.
RELATED CONTENT
On-demand water heaters provide an “endless supply” of hot water, but are they really “green”? Ther...
Conventional water heaters heat water and store it until it’s used, but a lot of that heat is waste...
Energy and water spending bill clears for Obama's pen, homeland security bill next...
Your woodstove can heat more than your home. This hot water heating system uses extra heat to produ...
There are several types of solar water heating systems. Learn more using solar energy to heat water...
Now, insert the saw-edged washer into the shower head as
far as it will go, and refasten the whole affair to the
connecting waterline. Finally, try out your modification:
If the flow is too constricted, you'll need to
disassemble the fitting and cut deeper notches in the
washer. If the flow has not been reduced enough, however,
you should start anew with another washer (even though
doing so will inflate the project's cost to a full 4¢)
and remove smaller slices this time.
Since I retrofitted my shower head, I've found that the
water flow is about 25% of what it was before . . . and the
spray has the same force regardless of how far I turn the
faucet handles. All in all, this is one project that I
think has really given me my 2¢ worth!
Page:
<< Previous 1 | 2 |