Give New Life To Abandoned Tools

Image Gallery With a little huntin' and some tender loving care, you can have a shopful of refurbished tools.

Article Tools

Image Gallery

Print

E-mail

Comments

RSS

It's almost impossible to keep the old homestead (or apartment) together without the help of a whole gang of expensive implements. But, if you pick up other people's castoff tools and give 'em a bit of tender loving care, you can equip your workshop for pennies a year, and still have some tools left over for barter.

TOOL GRAVEYARDS

All you'll need to start your collection of these discarded treasures is a good nose for the kind of "hiding places" that junk tools usually end up in. And nothing will get you into those places quicker than a willingness to help clean out other folks' attics, basements, barns and similar graveyards of abused equipment.

Not so long ago, for instance, a friend asked me to lend a hand "redding up" the garage that came with his new apartment. I did so, and was rewarded with two old axe heads and a ball-peen hammer. And, on another occasion, the bed of a newly purchased, 1956 pickup produced five pairs of shears, a hacksaw frame, a keyhole saw, two cold chisels and many other perfectly good tools that hid their glory under coats of rust and neglect. (Of course, if you don't mind spending a little cash, there are many unwanted but excellent tools to be found at garage sales and auctions.)

FROM BEAST INTO BEAUTY

It's easy enough to turn the misused instruments that you find into serviceable implements. To begin, soak your "discoveries" overnight in a five-gallon bucket of used motor oil. This oil bath serves two purposes: The oil loosens surface rust and corroded joints, and also arrests oxidation to prevent further damage.

One of the most valuable items in tool restoration is a vise, your "third hand." (If you don't have one, you can use a clamp to fasten the tool to a workbench or table.)

When the oil has done its work, use the vise and an electric drill with a three-inch wire-wheel attachment to further clean the tools. (I prefer this arrangement to a bench grinder with a wire wheel, because the work piece remains stationary and I can see when the metal is clean.) For a thorough and quick job, adjust the direction the vise faces and clamp the tool in as many different positions as necessary to get at all the blighted areas. You'll find that the rust comes off readily, but don't try to remove metal with a wire wheel, it just won't do the job.

RSS | Comments | E-mail | Print