Feedback on... THERMOSTATICALLY OPERATED WATER VALVES FOR THE DOME-COVERED FISHPOOL
March/April 1976
By Nelson Hochberg
RELATED CONTENT
The average suburban family can grow all the animal protein it needs by stocking small African fish...
Healthy, sweet and savory: Recipe for whole-wheat apricot sage breadsticks...
THE HEALTHY PLATE: Recipe for Pumpkin-Cranberry Spice Cake...
With just five minutes a day of effort, you can make superhealthy breads with nutritious whole grai...
Wow. That's some title. But Richard Read did ask for help in finding a way to automatically control the temperature of his mini-fish-farm (see MOTHER NO. 32, page 34).
Maybe I can off or that assistance.
The simple thermostats used in the cooling systems of cars, trucks, and other vehicles (cost, about $2.00 each) can—with a little modification—automatically regulate the temperature of water flowing into such an aquatic food reserve. (The modification is necessary because these regulators are ordinarily set to open at around 160 degrees Fahrenheit . . . 80 degrees higher than the 800 temperature that Reed's tilapia find most comfortable. The alteration, however, can be easy . . . so don't lot it frighten you.)
The smallest thermostats, and therefore the best ones for our purposes, are those made for the newer model Chevrolets. Almost any brand of new or replacement automobile water temperature regulator, though, can be made to work the way we want it to.
The easiest of these thermostats to adapt to our use are the ones with a small temperature-adjustment screw that's held at any desired setting with a dab of paint on its threads. If you can find one of these babies, grab it. Just by tightening or loosening that little screw, you'll be able to regulate the valve inside so that it passes only water which is the temperature you want.
If you're not lucky enough to run across a screw-adjusting thermostat, pick up one of the regulators built around a "gate" that operates like a swinging door. By bending up the sides of such a thermostat as shown in the accompanying drawing, testing the device, refining the bonds, testing again, etc., you can fine tune the thermostat until it opens at any temperature between 80 and 190°.
The testing part of this calibration, by the way, is quite easy. Just hold the regulator in a pan of water with a thermometer while the liquid is allowed to heat on a stove. Then simply note the temperature of the water at the time the thermostat opens. (it's important for accuracy's sake, of course, that neither the thermostat nor the thermometer touches the pan during one of these tests. Support them side by side or together in the water with a twist of wire, pair of long-handled pliers, or whatever while each calibration is being run.)
When the thermostat has been adjusted to your satisfaction, push it into a large piece of plastic pipe and position the regulator so that it will, indeed, regulate the flow of water through the pipe as it opens and closes. Then, using fittings on both ends of the assembly, mount the enclosed thermostat in the water line that foods your fish tank. (Make sure the regulator is turned the right way, or it won't start and stop the flow of water as it opens and closes.) The thermostat should be located as close as possible to the source of the water's heat.
