BUILD A HOME FROM RAILROAD TIES
Sam Owen talks about building a home from railroad ties picked up free, using only materials worth $300 for the basic structure of a 2,200 square-foot, three-bedroom house.
March/April 1971
By Sam Owen
THE MATERIALS FOR THE BASIC STRUCTURE OF THIS 2,200 SQUARE-FOOT,
THREE-BEDROOM HOUSE COST ONLY $300.00
RELATED CONTENT
Author discovered hanging around the rail yard benefits his garden as he collects the discarded pea...
Railroad Red March/April 1988 Last Laugh When ideas fail, words come in very handy.—Goethe Well sir...
How to add an old railway car to country property, including prices, zoning laws, caboose buying ad...
Pssst! ... hey kid, Wanna Buy a caboose? January/February 1972 In the early morning, before most pe...
PROVINCIAL PRESS/Box 276, Spokane, Wash. 99210/$5.00a year
The comfortable 2,200 square foot, three-bedroom house studied here took one couple, with occasional help from their friends, five summer vacations' spare time to complete. The three-hundred railroad ties used in the walls were picked up free. Mortar material cost $300.00. This compares with a cost of $7.00 per lineal foot for stud walls with bat insulation, gypsum board, and exterior wood siding.
The house has served as the family's permanent home through ten palouse winters, the walls showing their age only in hairline wood shrinkage cracks between tie and mortar.
The ties were laid horizontally in masonry fashion. The same material serves as structure, insulation, and interior and exterior surface. The rough, unfinished, organic material provides a mellow, rustic appearance.
Railroad ties have an 8" X 8" section and are treated with creosote oil, a preservative derived from coal tar. The ties used should be at least ten years old. By then, enough of the creosote will have evaporated so that its smell will not be noticed. Only the softwood (e.g. fir) ties should be used. Hardwood (e.g. oak) ties will shrink too much for this purpose.
The ties were stacked with 2" spacer blocks separating them to leave joint spaces. The most uniform ties were used for interior partitions. In the exterior walls the beams were laid to present the best face to the inside, and that face of the wall was plumbed even, putting all irregularities to the weather. Electrical conduit runs were then made within the joint spaces.
The wall may be braced plumb by constructing vertical bracing in pairs facing each other on either side of the wall and far enough from it to allow tamping behind. The ties may be held in place with blocking to each one from the braces. Block at ties only, leaving joints free for tamping.
Corners were jointed as in block masonry with alternate beams from each wall continuing through. At each corner a steel dowel was let down through the ends of the ties, the full height of the wall. The holes receiving it may most easily be drilled as each timber is stacked.
Scrap nails were toenailed into the top and bottom faces of each tie in two rows along both edges and at four inches on center along the length of the beam. The tops of the nails' may be bent inward to simulate hooks. Leave enough space at the edge of the tie for covering the nails with mortar. There is no chemical bond between mortar and wood. The nails mechanically bond the two after the mortar has dried.
