THE RETURN OF THE SOD ROOF

Enlarge Image Image Gallery

Two young Plainfield, Vermont builders — Tim Rice and Steve Jacob — have decided that the time is right for a revival of the old-time sod roof. They just may be right. Sod roofs are largely free for the labor, the materials are easily found in most back yards, sod is one of the most fireproof materials going and it makes excellent insulation for all but the most severe climates (some Vermonters with turf-topped homes have seen 50 below with no complaints).

According to Tim and Steve, there's no reason why anyone building a house couldn't top it with sod . . . at least with a little advance planning. The stud construction of the typical frame structure, for instance, doesn't lend itself to sod roofing but log cabins and buildings of post and beam design are especially well suited for such a topping. The "yes or no" difference is in the amount of weight each type of structure will support.

Allowing for snow loads and your family gathering for summer breakfast on top of the house, figure that the beams and rafters under a sod roof will have to carry 100 pounds per square foot. This is twice as much weight as is supported by the corresponding beams and rafters under an ordinary roof.

Many early homesteaders selected the wood for their sod roofs' joists and supports by eye and used the byguess-and-by-gosh method of calculating the timbers' dimensions. Such a trial and error approach can be pretty expensive and I don't recommend it . . . but if you insist on giving it a try, be dang sure to build your roof's substructure about twice as strong as you think seems reasonable. Better yet, forget such guesstimations entirely and get some professional help with the calculations.

If you live near a university, you can probably find an engineer who'll figure out the underpinnings of your house's sod top for a very small fee. Almost any reputable building supply house will help you with the calculations too . . . especially if the folks working there know that you intend to order materials from them. If these sources of help fail you, Tim Rice has agreed to lend a hand. Just send a floor plan that he can sketch on, a drawing of what you want the roof to look like and $20 to Tim in care of me, Hal M. Landen, Box 151, Plainfield, Vermont 05667. I'll forward the letter to Tim, who will then tell you all you need to know about the size and spacing of rafters, beams, sheathing, etc. for your building. Please allow four weeks for this service.

Tim, who enjoys sharing his knowledge and experience with the construction method, advises that a sod roof works best when it has some but no more than four inches of pitch—or fall—to the foot. He says, though, that a perfectly flat roof can be made watertight if it is carefully planned. (EDITOR'S NOTE: Judging from the near—45° slopes on the sides of one of the houses shown here, a pitch of far more than four inches can also be made to work satisfactorily.)