Make your own CULTIVATOR
(Page 2 of 2)
I scavenged my digging tines from an old field cultivator
("quack digger"). I put the tines on the machine, took a
piece of pretty sturdy 1/2-inch steel rod, ran it through
the hole mounts and secured them on both sides of the
machine.
RELATED CONTENT
It took one staffer and some old bike parts to come up with the hoe-stess with the mostest. Learn h...
How a little bit of ingenuity combined a junked bicycle with a weed-filled vegetable patch and crea...
HOME GARDEN'S EXPERTS DESIGN A VEGETABLE MINI-GARDEN FOR $10 May/June 1974 No, you don't need a cou...
The lifting of the tines could be done with an expensive
electromechanical device, but I found a simple piece of 4x4
red oak, spanning the width of the cultivator, does the
same thing. The closer you put the wood to the axle of the
tines, the higher the tines will raise for transporting
requirements.
As trial and effort showed, it takes three or four trips
over hard, overgrown ground to make the soil workable
enough to plant.
Early spring is the best time to put this cultivator to
work, before first growth starts.
That's it. Of course, these are the materials I had access
to. You can substitute materials lying around your yard. As
an Iowan, I deal mostly in facts, and the fact of the
matter is that you don't have to spend a lot to mechanize
your operation, too.
Fully detailed plans, parts list and instructions are
available by sending $10 to:
AN Field Cultivator Plan P.O. Box 101 Wadena, IA
52169 email: garyv@mwci.net
Page:
<< Previous 1 | 2 |