LET THERE BE SKYLIGHT
(Page 2 of 2)
Tools needed:
hammer
saw
square
pencil
RELATED CONTENT
One of the best ways to avoid the misery of poison ivy or poison oak exposure is to learn how to re...
ASH PILE,TRASH PILE November/December 1970 by RUTH HAMPTON Successful gardening like successful par...
Building a wooden cradle....
WE BUILT THIS SIX-SIDED OAK CABIN FOR JUST $120! September/October 1977 Cheryl and I are lucky," sa...
Bonnie Roycewicz discovers eating honey helps bedwetting; N.M. McGee rubs cooking oil on appliance ...
Constructing the Skylight
When it's time to go to work, be sure to pick a day when
you'll have a few hours of sunshine. (These directions are
for an already existing building, but if you're building a
new home, it's even easier.)
1. Remove all roofing where hole is to be cut.
2. Cut hole in your roof the size of your window. Being on
the lazy side, I used a chain saw, but a hand saw will work
just as well.
3. Measure and cut 2" x 6" board and frame under edge of
hole, making a casing for the window to set in.
4. Measure and cut 1" x 2" boards to fit inside of casing
flush with bottom and nail.
5. Set window in place (and smile because it's startin' to
take shape)
6. Build a frame from the 1" x 4", two inches larger on
all
sides than the hole and nail to roof.
7. Cut 1" x 6" or 1" x 8" to fit inside across middle of
frame. Cut so board tapers to four inches at the ends and
nail in place.
8. Tar and paper around frame on roof.
9. Cover with plastic and staple in place.
10. Nail lath around outside of frame to help secure
plastic.
Now enjoy all the warm sunlight shining in through your
roof. In the evening you won't have to light your lamps as
early, which will save you what it cost to build this
economical, practical skylight.
Page:
<< Previous 1 | 2 |